|
|
Post by Osram on May 21, 2003 12:20:22 GMT -5
Making copies on top of the copyboard glass, okay. But when using the RDF for only a single copy, its stop during scanning (scanner just stop at the middle) and E213 displayed.Any idea?
|
|
|
|
Post by freebyrd116 on May 21, 2003 14:25:27 GMT -5
I believe there is a tech bulletin available on that error. Something to do with putting a mylar sheet behind the white belt to stop static discharge from screws protruding through RDF frame and causing microprocessor error.
I will look it up and get back to you.
|
|
|
|
Post by Osram on May 22, 2003 10:06:29 GMT -5
Correction! Actually the problem appeared in stream reading mode (Setting in Option Menu > DF Feed Switch set to Off) . Any ideas (waiting freebyrd's anwer)?
|
|
|
|
Post by lostintexas on May 22, 2003 21:31:05 GMT -5
tech bull 6050-9
if the movement of the scanner lock sol. is larger than the standard value it will not retract the plunger sufficiantly and the scanner lock in the sliding reading copy mode thereafter causeing an error e213 error code
verify the movement of the scanner lock sol and ensure that it is within the standard value (10.5 +- 0.5) if it is not, perform the adjustment.
|
|
|
|
Post by freebyrd116 on May 22, 2003 21:33:09 GMT -5
Thanks lostintexas......
I was still looking for that bulletin.....
Osram, let us know how you make out with the info.
Admin
|
|
|
|
Post by Osram on May 23, 2003 21:21:50 GMT -5
Thanks lostintexas ! Much appreciated....
But.....how to do the adjustment? Can it be done in Service Mode ?
|
|
|
|
Post by lostintexas on May 23, 2003 23:23:06 GMT -5
1. remove the rear cover
2. remove the multifeeder assy.
3. re-adj the movement of the scanner sol. ( the sol has little slots in it.
the sol may be bad or dirty, take a volt/ohm meter and you can figure out the rest, enable your email and i will email you the pdf. mine in in my profile, just mention something about this thread and i will respond.
lostintexas_nospam_@cox.net
-mike (take the no spam part out)
|
|
|
|
Post by Osram on May 24, 2003 9:16:27 GMT -5
I have enabled my email. Kind of you....i'm glad to have this forum.Really helpful.
Thanks to all who make this forum happened.
osram@tm.net.my
|
|
|
|
Post by freebyrd116 on May 24, 2003 9:57:07 GMT -5
Thanks Osram,
Come back often and tell others about us!
Admin
|
|
|
|
Post by lostintexas on May 24, 2003 10:36:53 GMT -5
Osram, you have mail
-mike
|
|
|
|
Post by Osram on May 25, 2003 5:39:14 GMT -5
Yap, I have your mail. Thanks, lostintexas and freebyrd.
|
|
|
|
Post by Osram on May 26, 2003 9:56:34 GMT -5
Its worked......thanks again.
|
|
|
|
Post by lostintexas on May 26, 2003 20:59:35 GMT -5
no problem, anytime.
-mike
|
|
